Installing Location
Outdoor and Indoor
Icon ceiling fans can be installed in a variety of locations both inside the home as well as in out door living areas provided that the roof is sealed and there is no opportunity for water to encroach on the motor. Both timber and sail cloth blades are fine for outdoor installations however we do recommend sail cloth blades over timber blades as they will withstand outdoor conditions better.

Please note if timber bladed fans are installed in outdoor locations the blades may needed to be replaced more regularly as the blades may warp to exposure to higher levels of moisture in the air.

Motor Housing
The Icon motor housing is made from die cast aluminium thus joining within the material is eliminated. This significantly extends the longevity of the product, as the opportunity for rust and material degradation is almost completely removed.

The Icon motor housings are available in a range of finishes including white, white birch, black, brushed aluminium and polished aluminium.

Motor
The Icon ceiling fan has a 16 pole, 172mm x 14mm motor. All Hunter Pacific fan motors use vacuum impregnated high-grade copper windings, silicon-steel stators and sealed bearings for long life and quiet operation. The wall controller in conjunction with the stator windings ensures optimum speeds for all conditions. With minimal motor movement and a cool operational temperature, this powerful motor is guaranteed lasting operation.

Blade Material
Wooden Blades
Icon ceiling fans are 4 bladed ceiling fans. The blades are made from New Zealand plywood and are placed into sets based on accurate weight measurements removing almost all unwanted movement during fan operation. Blades are painted with finishes that complement the motor housing colours and the paint also acts as an additional layer of protection on the wooden blades.

Sail Blades
Accessory sail blades are available for Icon ceiling fans. With sail blades attached the overall diameter of the Icon ceiling fan is 1650mm (65"). The blades consist of aluminium frames with cloth inserts. The inserts are available in a range of colours. Please see the Icon sail blades section under the products section for a complete colour listing.

Blade Pitch
The blade pitch is 12 degrees allowing the fan to produce greater air flow.

Accessories
Remote
Down rods (26mm)
45 degree ceiling canopy kits
165cm Sail Blades
Icon Light Kit

Hunter Pacific has designed these accessory components to simplify the installation of our ceiling fans in tricky locations. Please see the accessories section for more information.

If the distance between the ceiling fan and the floor is greater than 2.4m (8ft), please see the accessories section for solutions to solve these problems.