|
KINETIC
The Kinetic is the only Hunter Pacific ceiling fan which has a glass
bottom motor housing. The glass base plate is held with chrome finished
screws which gives the fan a more modern appearance. This glass bottom
is attached to the motor housing and regardless of whether the customer
has a light or not the glass plate is always present. However if a
light fitting is desired, customers can add a light assembly which can
be inserted between the glass plate and upper half of the motor
housing. The Kinetic has timber blades and is available in a range of
colours.
Installing
Location
Outdoor and Indoor
Kinetic ceiling fans can be installed in a variety of locations both
inside the home as well as in outdoor areas provided that the roof is
sealed and there is no opportunity for water to encroach on the motor.
Please note if timber bladed fans are installed in outdoor locations
the blades may needed to be replaced more regularly as the blades may
warp to exposure to higher levels of moisture in the air.
Motor
Housing
The Kinetic motor housing is made from die cast aluminium thus joining
within the material is eliminated. This significantly extends the
longevity of the product, as the opportunity for rust and material
degradation is almost completely removed.
Kinetic
ceiling fans are available in a range of finishes including white,
white birch, black, brushed aluminium and polished aluminium.
Motor
The Kinetic ceiling fan has a 16 pole, 153mm
x 18mm motor. All Hunter Pacific fan motors
use vacuum impregnated high-grade copper windings,
silicon-steel stators and sealed bearings for
long life and quiet operation. The wall controller
in conjunction with the stator windings ensures
optimum speeds for all conditions. With minimal
motor movement and a cool operational temperature,
this powerful motor is guaranteed lasting operation.
Blades
Wooden Blades
The Kinetic is a 4 bladed, 1320mm (52") ceiling fan. The blades are
made from New Zealand plywood and are placed into sets based on
accurate weight measurements removing almost all unwanted movement
during fan operation. Blades are painted with finishes that match the
motor housing colours and the paint also acts as an additional layer of
protection on the wooden blades.
Blade
Pitch
The blade pitch is 12 degrees allowing the fan to produce greater air
flow.
Accessories
Remote
Down rods (26mm)
45 degree ceiling canopy kits
T-hook
Light assembly inserts
Hunter
Pacific has designed these accessory components to simplify the
installation of our ceiling fans in tricky locations. Please see the
accessories section for more information.
If the
distance between the ceiling fan and the floor is greater than 2.4m
(8ft), please see the accessories section for solutions to solve these
problems.
|
